Maxillary 1st premolar
Permanent Maxillary Premolars
Maxillary First Premolar — anatomy, surfaces, roots, occlusal features and development
Overview of Maxillary Premolars
- Premolars are present in the permanent dentition.
- The term bicuspid is commonly used because premolars usually have two cusps.
- Premolars are developed from the same number of lobes as their anterior teeth.
- The lingual cusp is developed from the lingual lobe and is represented by the cingulum in incisors and canines.
- The middle buccal lobe is strongly developed in premolars.
- The middle buccal lobe of the premolar corresponds to the middle labial lobe of the canine.
- The maxillary premolars therefore resemble canines when viewed from the buccal aspect.
- The buccal cusp of the maxillary first premolar is long and sharp.
- It assists the canine as a prehensile or tearing tooth.
- The second premolars have shorter cusps than the first premolars.
- Their cusps articulate with opposing teeth during jaw closure and assist in grinding.
- Premolar crowns are shorter than maxillary canine crowns.
- Their roots are also shorter than canine roots and approximately equal to or slightly longer than molar roots.
Maxillary First Premolar
The maxillary first premolar has two well-defined cusps: one buccal and one lingual.
The crown is approximately 1.5 to 2 mm shorter than the canine. It is angular from the buccal aspect, and the buccal and lingual line angles are prominent.
The mesial and distal contact areas are nearly at the same level. The root is shorter than the canine.
The first premolar has several features that distinguish it from anterior teeth. These include its greater relative faciolingual dimension, broader occlusal area, contact areas that are more nearly at the same level, less curvature of the cervical line, and a shorter cervico-occlusal crown.
Buccal Aspect
From the buccal aspect, the crown is roughly trapezoidal and shows little curvature at the cervical line.
Buccal crown features
- The buccal surface is convex.
- The middle buccal lobe is strongly developed.
- The continuous ridge from the buccal cusp tip toward the cervical margin is called the buccal ridge.
- Mesial and distal developmental depressions are present at or near the occlusal third of the buccal ridge.
- The mesial and distal depressions mark the areas between the middle buccal lobe and the mesial and distal buccal lobes.
Buccal cusp
- The buccal cusp is long and pointed.
- The mesial cusp slope is relatively straight and longer than the distal cusp slope.
- The distal cusp slope is shorter and more curved.
- The tip of the buccal cusp lies distal to a line bisecting the buccal surface.
- The mesial slope may show a notch or concavity.
The mesiodistal width of the crown is about 2 mm less at the cervical area than at its greatest mesiodistal measurement.
The root outline resembles that of the canine, but the roots are shorter. The root is generally within the confines of the crown when viewed from the buccal aspect.
Lingual Aspect
From the lingual aspect, the general outline of the maxillary first premolar is almost the reverse of its buccal outline.
- The crown becomes narrower toward the lingual because the lingual cusp is narrower mesiodistally than the buccal cusp.
- The lingual cusp is smooth and spheroidal from the cervical portion toward the cusp tip.
- The cusp is pointed, with its mesial and distal slopes meeting at an angle of about 90°.
- The lingual surface is convex at all points.
- The smooth convexity of the lingual surface may end at the cusp tip as the lingual ridge.
- The mesial and distal outlines of the lingual portion of the crown are convex.
- The lingual portion of the crown is narrower than the buccal portion.
The lingual root is smooth and convex when two roots are present. Its apex tends to be blunter than the buccal root apex.
Mesial Aspect
From the mesial aspect, the crown is roughly trapezoidal. The longest side is toward the cervical portion and the shortest side is toward the occlusal portion.
Mesial crown features
- The buccal outline of the crown is smoothly curved from the cervical line toward the buccal cusp.
- The crest of curvature of the buccal outline is usually near the center of the middle third.
- The lingual cusp tip lies lingual to the lingual border of the lingual root.
- The lingual cusp is shorter than the buccal cusp.
- The difference between the cusp heights is approximately 1 mm on average.
A well-developed developmental groove may occur in the enamel of the mesial marginal ridge. It is aligned with the developmental depression on the mesial surface of the root, although the two are not usually connected.
This marginal groove continues across the central groove of the occlusal surface and crosses the mesial marginal ridge before ending on the mesial surface of the crown.
When two roots are present, the buccal and lingual roots are clearly separated from the mesial aspect. The bifurcation usually extends for about half of the total root length.
Distal Aspect
The distal aspect resembles the mesial aspect in general form, but several features are different.
- The crown surface is convex at most points.
- A small flattened area may occur cervical to the distal contact area and toward the buccal side.
- The cervical line shows less curvature distally than mesially.
- The cervical line may extend in a slight arc from buccal to lingual.
- The distal contact area is somewhat broader and more rounded.
The distal portion of the root may be flattened, with no prominent developmental signs. In some specimens, the root outline may become nearly straight above the apical portion.
Occlusal Aspect
The occlusal outline of the maxillary first premolar is roughly six-sided or hexagonal.
Occlusal outline
- The six sides are formed by the mesial, distal, buccal and lingual boundaries and the marginal ridges.
- The buccal sides are nearly equal.
- The mesial side is shorter than the distal side.
- The mesiolingual side is shorter than the distolingual side.
- The buccolingual crown dimension is greater than the mesiodistal dimension.
- The crown is wider buccally than lingually.
Cusp relationship
- The buccal cusp is prominent and relatively long.
- The lingual cusp is shorter and more sharply pointed.
- The buccal cusp tip is nearer the center of the root trunk than the lingual cusp tip.
- The buccal and lingual cusp ridges form the main boundaries of the occlusal surface.
Developmental grooves and fossae
- The occlusal surface usually has no supplemental grooves, making it relatively smooth.
- A well-defined central developmental groove divides the occlusal surface approximately equally buccolingually.
- The central groove extends from near the distal marginal ridge toward the mesial marginal ridge.
- The mesial and distal marginal developmental grooves join the central groove.
- These grooves form the mesial and distal developmental pits.
- A mesial triangular fossa lies just distal to the mesial marginal ridge.
- A distal triangular fossa lies just mesial to the distal marginal ridge.
When viewed from the mesial aspect, the tip of the buccal cusp is nearer the center of the root trunk than the lingual cusp.
Roots and Root Variations
The maxillary first premolar commonly has two roots: one buccal and one lingual.
Root surface features
- The root trunk is relatively long and makes up about half of the root length.
- The bifurcation is positioned more occlusally in teeth with two roots.
- The buccal root may show a buccal inclination above the bifurcation.
- The buccal root may curve buccally or lingually in its middle or apical portion.
- The lingual root is generally rather straight above the cervical line, although considerable curvature may occur.
- The lingual root may incline buccally or lingually toward the apical region.
Development and Measurements
Developmental milestones
Average measurements
Quick Revision
- Maxillary premolars lie between the canines and molars.
- The maxillary first premolar has one buccal and one lingual cusp.
- The buccal cusp is long, sharp and prominent.
- The lingual cusp is shorter and more sharply pointed.
- The crown is shorter than the maxillary canine.
- Most maxillary first premolars have two roots and two pulp canals.
- The mesial developmental depression is an important identifying feature.
- The occlusal outline is roughly six-sided or hexagonal.
- The central developmental groove divides the occlusal surface.
- The first evidence of calcification occurs at about 1½–1¾ years.
- Enamel is completed at about 5–6 years.
- Eruption occurs at about 10–11 years.
- Root completion occurs at about 12–13 years.