Mandibular 1st Premolar
Mandibular First Premolar
The mandibular first premolar is the fourth tooth from the median line and the first posterior tooth in the mandible. It combines important features of both the mandibular canine and the posterior teeth.
General Characteristics
The mandibular first premolar is a transitional tooth with important canine-like and premolar-like features.
Position and General Form
- The mandibular first premolar is the fourth tooth from the median line.
- It is the first posterior tooth in the mandible.
- Two mandibular premolars are present on each side of the mandible.
- The first premolar lies immediately posterior to the mandibular canine and anterior to the molars.
- The mandibular premolars develop from four lobes.
- The mandibular first premolar is usually developed from five lobes, including three buccal lobes and two lingual lobes.
- The first premolar has a large, long and well-formed buccal cusp.
- The lingual cusp is small and usually nonfunctioning.
- In some specimens, the lingual cusp may be absent.
The mandibular first premolar is strongly canine-like. Its large, sharp buccal cusp is the only normally functioning occluding cusp.
Relationship to Other Teeth
- It has several characteristics in common with the mandibular canine.
- The sharp buccal cusp contributes to its canine-like appearance.
- The mandibular second premolar has more of the characteristics of a small molar because its lingual cusps are better developed.
- The mandibular second premolar may therefore produce a more efficient occlusion with opposing teeth.
- The first premolar is usually smaller than the second mandibular premolar.
Buccal Aspect
The buccal aspect is dominated by the large buccal cusp and the strong resemblance to the mandibular canine.
Crown Features
- The crown is nearly bilaterally symmetrical from the buccal aspect.
- The middle buccal lobe is well developed and produces a large, pointed buccal cusp.
- The mesial buccal cusp ridge is shorter than the distal buccal cusp ridge.
- The buccolingual measurement is similar to that of the mandibular canine.
- The occlusal surface slopes sharply lingually in a cervical direction.
- The crown is roughly trapezoidal from the buccal aspect.
The buccal cusp is long, sharp and prominent. It is the main occluding cusp and is an important feature for identifying the mandibular first premolar.
Contact Areas and Cervical Line
- The contact areas are broad from the buccal aspect.
- The mesial and distal contacts are almost at the same level.
- The contact level is slightly more than halfway from the cervical line toward the cusp tip.
- The cervical margin shows little curvature buccally.
- The mesial and distal cervical curvatures approach the center of the root buccally.
Root from the Buccal Aspect
- The root is approximately 3–4 mm shorter than the mandibular canine root.
- The buccal portion of the root resembles that of the mandibular canine.
- The root is narrower mesiodistally near the cervical region.
- The buccal surface of the crown is more convex than that of the maxillary premolars.
- The root commonly tapers toward a pointed apex.
The enamel of the buccal crown surface is generally smooth, with few developmental grooves. When present, developmental lines are very fine horizontal lines in the cervical region.
Lingual Aspect
The lingual aspect is characterized by a small lingual cusp and a crown that narrows toward the lingual side.
Lingual Crown Features
- The crown tapers toward the lingual side.
- The lingual measurement mesiodistally is less than the buccal measurement.
- The lingual cusp is small and may be poorly developed.
- The major portion of the crown is formed by the middle buccal lobe.
- From the lingual aspect, most of the mesial and distal surfaces can be seen because of the narrow lingual portion.
- The occlusal surface slopes greatly toward the lingual in a cervical direction.
A characteristic feature of the lingual surface is the mesiolingual developmental groove. It acts as a line of demarcation between the mesiobuccal lobe and the lingual lobe and extends into the mesial fossa of the occlusal surface.
Root from the Lingual Side
- The root is much narrower on the lingual side.
- The lingual root surface is narrow, smooth and convex for much of its length.
- This form allows much of the mesial and distal root surfaces to be seen.
- Developmental depressions may occur on the root, particularly on the mesial surface.
- The root generally tapers toward a pointed apex.
Mesial Aspect
The mesial aspect shows the characteristic lingual inclination of the crown and the relationship of the buccal cusp to the root.
Crown and Cusp Position
- The crown outline from the mesial aspect is roughly rhomboidal.
- The lingual lobe is positioned lingual to the outline of the root.
- The buccal cusp tip is located slightly lingual to the root outline.
- The cusp tip is approximately in line with the lingual border of the root.
- This differs from maxillary posterior teeth, where the buccal and lingual cusp tips are more closely aligned over the root trunk.
From the mesial aspect, the buccal cusp is centered over the root in some specimens but may appear slightly lingual to the center.
Cervical and Root Features
- The buccal outline of the crown is prominently convex from the cervical line to the cusp tip.
- The crest of the buccal curvature occurs in the middle third of the crown.
- The lingual outline of the crown is less convex than the buccal outline.
- The root outline is tapered and ends in a relatively pointed apex.
- The lingual root outline may be straight, while the buccal outline is more curved.
- The buccal surface of the root may show a shallow developmental depression.
- Deeper developmental grooves may occasionally be present, sometimes extending into a bifurcation in the apical third.
The root may show a slight distal inclination, although mandibular premolar roots commonly show little curvature or curve distally.
Distal Aspect
The distal aspect differs from the mesial aspect in the form of the marginal ridge, contact area and developmental depression.
Distal Crown Features
- The distal marginal ridge is higher above the cervical line than the mesial marginal ridge.
- The distal marginal ridge is more nearly at right angles to the long axis of the crown and root.
- The lingual cusp ridge is confluent with the marginal ridge.
- The distal marginal ridge has no developmental groove.
- The distal surface of the crown is smoothly convex with a spheroidal form.
The distal contact area is broader than the mesial contact area and is centered in the same relation to the crown outline.
Distal Root Features
- The distal root surface is more convex than the mesial root surface.
- A shallow developmental depression may be present on the root.
- The distal root surface slopes from the buccal margin toward the lingual side.
- The distal slope is generally more gradual than the corresponding mesial slope.
Occlusal Aspect
The occlusal surface shows considerable variation but retains several characteristic features of the mandibular first premolar.
General Occlusal Form
- The usual occlusal outline is roughly diamond-shaped and resembles the incisal aspect of the mandibular canine.
- Some teeth may resemble the occlusal outline of a mandibular second premolar.
- The middle buccal lobe forms the major bulk of the crown.
- The buccal ridge is prominent.
- The mesio-buccal and disto-buccal line angles are prominent, although rounded.
- The marginal ridges are well developed.
- The lingual cusp is small.
The occlusal surface commonly contains two depressions, the mesial and distal fossae. These are separated by the triangular ridges, with the mesial depression associated with the mesiolingual developmental groove.
Occlusal Variations
- The occlusal outline may vary considerably among individual mandibular first premolars.
- Some specimens have a form closely resembling the mandibular canine.
- Other specimens may approach the form of the mandibular second premolar.
- The distal fossa may contain a developmental groove or additional supplemental grooves.
- The mesial fossa commonly shows the mesiolingual developmental groove extending from the mesial surface.
Features Common to Mandibular First Premolars
Crown Bulk
The middle buccal lobe forms the major bulk of the crown.
Buccal Ridge
The buccal ridge is prominent and forms an important part of the crown anatomy.
Line Angles
The mesio-buccal and disto-buccal line angles are prominent but rounded.
Contact Areas
The contact areas are relatively broad, with the distal contact generally broader than the mesial.
Lingual Cusp
The lingual cusp is small and less developed than the buccal cusp.
Marginal Ridges
The marginal ridges are well developed and contribute to the occlusal anatomy.
Developmental Milestones
The developmental timing and dimensions given for the mandibular first premolar are summarized below.
Developmental Timeline
Dimensions
The following dimensions are given in millimeters.
Key Features to Remember
Position
Fourth tooth from the median line and first posterior tooth of the mandible.
Buccal Cusp
Large, long and sharp; it is the main functioning occluding cusp.
Lingual Cusp
Small, less developed and usually nonfunctioning; it may occasionally be absent.
Mesiolingual Groove
A characteristic developmental groove extending from the mesial surface into the mesial fossa.
Occlusal Outline
Usually roughly diamond-shaped and often resembles the incisal outline of the mandibular canine.
Root
Approximately 3–4 mm shorter than the mandibular canine root and generally tapered toward the apex.